Exhaust Modifications

The exhaust I have had a rear exit, however when it was fitted, it was to high where it needed to pass under the guard. My aim is to have a nice side exit exhaust ready for rego, but this one will do now for testing and rego prep. So I could get it to fit with the guard, I cut the pipe where it exited the muffler and ground it back to the original flange. We then cut a piece of the old pipe at angle to use as a temporary tip. Using Steve's new MIG welder and our new found welding skills, we welded the temporary tip into place which now exits just under the guard and in front of the tyre, at about 45 degrees to the car and ground.