Cooling System - Part 2
I needed to source a 32mm OD aluminum pipe to connect the rear hoses to the radiator. I also needed to splice in the aluminum block that holds the water temp sender. I bought a couple of nice stainless steel P clips to connect the pipe to the block, however these needed to be drilled out to fit the bolts. I managed to wreck one while drilling but I was able to fabricate a rubber lined P clip from aluminum in no time to replace it. This is the last bit of the cooling system (save for the missing radiator cap) and I can now fill it and test for any leaks before adding the coolant. Cooling system finished!
I needed to source a 32mm OD aluminum pipe to connect the rear hoses to the radiator. I also needed to splice in the aluminum block that holds the water temp sender. I bought a couple of nice stainless steel P clips to connect the pipe to the block, however these needed to be drilled out to fit the bolts. I managed to wreck one while drilling but I was able to fabricate a rubber lined P clip from aluminum in no time to replace it. This is the last bit of the cooling system (save for the missing radiator cap) and I can now fill it and test for any leaks before adding the coolant. Cooling system finished!
No comments:
Post a Comment