Rear Stabilisers

One of the missing parts delivered during the week was the bolts that fitted into the top of the rear wishbone, that connects to the linkage on the rear stabiliser. I had been waiting for the diff to go in before fitting the stabiliser bar anyway so this was no great delay. The stabiliser mounts bolt onto the back of the cockpit wall, then connect to the wishbones via an adjustable linkage (this is visible above the half shaft, just above Steve's shoe which seems to have made it into another shot?).


These weren't overly complicated to fit, however it was good to have Steve's car here as a "template" to check the alignment and final configuration of washers and conical spacers. This means the rear suspension is finished and I can start working on the fuel system.